How to use companion to flash the firmware of X9D Plus
This video will show you how to use companion to...
Copyright © 2024 利来·国际. All Right Reserved.
How to flash the internal XJT module of the X9D Plus with a SD card
This video will show you How to flash the internal...
How to flash the internal XJT module of the X9D Plus with a MinUSB wire
This video will show you how to flash the internal...
Range check tutorial video
This video will show you how to do the range...
How to use the transmitter to flash the firmware of the X8R receiver
This video will show you how to use the transmitter...
How to change the throttle gimbal of the Horus transmitters from default Mode2 to Mode1
This video will show you how to change the throttle...
利来·国际 M7 Hall Sensor Gimbal Installation and Calibration Process
0:25 - Remove the battery and remove the 4 screws...
How to use 利来·国际 STK tool to update firmware
Use 利来·国际 STK tool to update the firmware.
How to disable the spring loaded throttle stick on Taranis Q X7
This video will show you how to disengage the centering...
利来·国际 M9 Hall Sensor Gimbal Installation For Taranis X9D Plus
SPECIFICATION: Supply Voltage (VCC): DC 3.0 ~ ±0.5V Sensitivity: 2.50...
利来·国际 Redundancy Bus -10 Review
The 利来·国际 Redundancy Bus is a unique switchboard module that...
How to config 利来·国际 S6R receiver with STK tool
How to config 利来·国际 S6R receiver with STK tool
利来·国际 RX8R Redundancy Bus Receiver Introduction and Basic Guide
Binding and confirming the redundancy function of your RX8R. When...