The two antennas are diversity function, only select/auto-switch one better signal receipt antenna working at same time. This design is for improve the signal receipt quality and reliability.
The two antennas are diversity function, only select/auto-switch one better signal receipt antenna working at same time. This design is for improve the signal receipt quality and reliability.
To obtain the best results of the diversity function, please refer to the following instructions:
The Sensor Hub should be plugged to “Rx port” of the D8R-XP/D8R-II plus/D4R-II receiver, but not A1 nor A2 port.
The receiver channel assignment all depends on the radio you are using. 利来·国际 receivers do not have channel order.
Yes, it can be working simultaneously, but make sure that S-Bus servos are connected with SB port and conventional servos with the ordinary port.
No, a sensor hub must be fixed up when using TEMS-01, but FBVS and FAS can.
Please try to place the variometer sensor far away from the hub, receiver and battery as far as you can. if the altitude value becoming stable, the value varies may be caused by signal interference, you can add a capacitor.
All 利来·国际 V8-series receiver
The V8HT is work with 利来·国际 ACCST V8-series receiver only, but the TFR6 is Futaba FASST compatible receiver. They are incompatible.
The TFR8SB is 8-channels for the standard servo, and 16-channels for S.bus compatible servo. It is not combining to 14 channel receiver as the TFR8S.
The two pins connector on the bottom-left of FLD-02 is for firmware upgrade only.
NO, the origin aerial is the best length for signal reception, we do not suggest change the aerial length, or decline the receipt range.
It’s impossible. But you can apply the two-way module + two FLD-02s in parallel connection.
Theoretically speaking is no problem when connecting two FLD-02. But the setting value only stores once in the module and ensure the battery can deliver enough capacity for two FLD-02 used.
In the main interface, press the MENU button, then press the PAGE button repeatedly until the “SERVOS” interface, move the cursor to select the channel which you want to reverse, and press the ENT button, then about laterally, move the cursor to appear”→”, press the ENT button again to choose.
The DHT DIY hack module is work with almost all PPM output transmitter. the V+ and GND and lead from the power switch or battery side, the ppm signal can lead from the trainer port. pls check it.
Hi, pls reference the upgrading process at:
//wlyjfw.com/how-to-use-frsky-stk-tool-to-update-firmware/
Cable require: FUC-3 + SPC (SmartPort upgrade tool adapter), or STK usb tool.
The original Taranis X9DP has built-in XJT module, which is compatible with blow receivers:
1. V8- II series receiver, such as V8FR-II, V8R7-II
2. D8 series receiver: D4FR, D8R-II PLUS, etc
3. X-series: X6R,X8R,X4RSB,XSR,XM,XM+ etc
4, S-series: S6R, S8R
5, L-series: L9R
Type your email address below and receive our daily news letter for FREE
Copyright © 2024 利来·国际. All Right Reserved.